Table of Contents
Advertisement
Position
For best results, choose a position where light does not fall directly on the screen and
away from sources of heat. Do not put objects with magnetic field nearby the television or it
could affect the quality of the colours.
Cleaning
Switch off and unplug the television and use only a lightly dampened soft cloth to clean it.
Do not use chemically active substances as these may damage the cabinet finish.
Standby
For convenience your television can be switched to standby with the remote control. To
preserve optimum picture quality (by de-magnetising the picture tube), we advise you to
switch off your television at the on/off switch regularly.
Switching on
1. Remove the battery cover from the remote control unit and install two AA type batteries
according to the diagram inside the battery compartment. Replace the battery cover.
Notice: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type.
2. Connect your aerial to the TV set.
3. Connect your TV to a 230 VAC power socket.
4. Switch on your TV with the power switch on the front panel.
If the screen does not light up, press a button P+ or P- on the front of the television set
or any key such as POWER,
Notes:
1. After switching the television set on by using power button on front panel, the set
switchs to the same mode as it was before switching off by this button. If TV set
was switched off by using the POWER key on remote control, it switches to standby
and the indicator LED on the front panel turns red.
2. After switching television set from standby to operating status, the indicator LED
turns to green from red.
Quick Start Guide
1. Fit the Batteries into the Remote Control according to the diagram in the battery compartment.
2. Plug your main home aerial into the TV set.
3. Plug your TV into the mains and switch ON by pressing the power button on the front panel. If
your TV screen does not light up, press the POWER,
to cancel standby mode.
4. On your remote control press the "OK" key once. The main menu will appear on the screen.
5. On your remote control use the key 18 (P+, P-) to select Installation icon.
6. On your remote control press the
7. On your remote control press the
On your remote control press the key P-
tune and store your local available TV stations. This may take a few minutes.
8. Select your favorite program by using the
9. Set your favorite volume level by using
Remark: If You forget the child lock code or dial it wrongly, press code 4711 on remote
control by pressing digital key to unlock the locked program.
10. You may change code the lock after TV will switch on. Refer to the instruction booklet for further
information about the many other facilities.
Remark: When there is no signal in the aerial socket, the TV screen will appear in blue colour
if the Blue back item is set to On in Features menu.
or
, 0, 1, ...9 on remote control.
,
key once to select Installation menu.
key four times to select Autostore item.
twice to run Autostore. Your TV will now automatically
,
keys or the digital keys.
,
keys.
2
key or any digital key on the hand unit
Advertisement
Table of Contents
