Datalogic MAGELLAN 1000i Product Reference Manual page 62

Interface Related Features
Keyboard Wedge — cont.
Intercharacter Delay
START / END
One-half of the delay specified below is inserted between scancodes within each character. If the transmission speed is too high, the
system may not be able to receive all characters. You may need to adjust the delay to make the system work properly. Selectable
from 000 to 255 in 10msec increments.
To configure this feature, scan the "START/END" barcode above to place the unit in Programming Mode, then the "Set Intercharacter
Delay," followed by the three digits (zero padded) from the Alphanumeric table in
your desired length. Exit programming mode by again scanning the "START/END" barcode above/
USB COM Interface Set-up
This interface uses the Microsoft Windows USB COM driver. Before plugging your reader into
the host PC, please ensure you have already copied the DLS_EUG_CDC_ACM.inf file pro-
vided by Datalogic to your PC and the reader's interface is set to USB COM.
1. When you first plug the reader into the PC, Windows will bring up the "Found New
2. Click on "Include this location in the search" and enter the path where the file
3. If a message appears that says the software has not passed Windows logo testing, press
4. Click on "Finish."
Once the install is complete, reboot the PC.
3-36
This feature does not apply to the USB Keyboard interface.
NOTE
PROGRAMMING BARCODES
DEFAULT SETTING FOR THIS FEATURE:
Hardware Wizard." Select "Install from a list" and click on "Next."
DLS_EUG_CDC_ACM.inf file is stored. Click on "Next."
"Continue" anyway.
Appendix C, Alpha-Numeric Pad
000 (No Delay)
Set Intercharacter Delay
representing
Magellan ®
1000i