Dell Latitude C810 Service Manual page 35

Removing and Replacing Parts : Dell Latitude C810 Service Manual
When the microprocessor module is correctly seated, all four corners are aligned to the same
height. If one or more corners of the module are higher than the others, the module is not seated
correctly.
NOTICE: Hold the microprocessor down while turning the cam lock screw to prevent
intermittent contact between the cam lock screw and microprocessor (see
Lock Screw").
2. Tighten the cam lock screw.
NOTICE: Do not over- or undertighten the screw. Tighten it until the screw indicator points to
the "closed" or "locked" indicator on the socket.
3. Replace the microprocessor thermal cooling assembly.
Closing the Microprocessor Retaining Clip
4. While pressing lightly down on the center of the retaining clip, insert a flat-blade screwdriver
into the latch mechanism and pivot the top of the screwdriver away from the clip to close the
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/L...Latitude/C810/C810_SERVICE_MANUAL/2e40520.htm (27 of 46)6/21/2004 1:32:50 AM
"Microprocessor Cam