Led Indicator; Valet Switch; Brake Lights (Mandatory); Parking Lights - Avital AviStart 4500 Installation Manual

LED Indicator

LED Indicator
1. Discuss placement with the owner. 1. Discuss placement with the owner.
2. Choose a location that is visible from both sides of the vehicle. 2. Choose a location that is visible from both sides of the vehicle.
3. Drill a ¼" hole. 3. Drill a ¼" hole.
4. Route the LED wires through the hole and press LED into place. 4. Route the LED wires through the hole and press LED into place.
5. Route the LED wires to the control unit. 5. Route the LED wires to the control unit.
6. Plug the RED LED connector into the control unit RED plug. 6. Plug the RED LED connector into the control unit RED plug.

Valet Switch

Valet Switch
1. Discuss placement with the owner. 1. Discuss placement with the owner.
2. Choose a location for the valet switch that is hidden, but convenient for 2. Choose a location for the valet switch that is hidden, but convenient for
the owner to access. the owner to access.
3. Drill a ¼" hole and mount the switch. 3. Drill a ¼" hole and mount the switch.
4. Route the valet switch wires to the control unit. 4. Route the valet switch wires to the control unit.
5. Plug the valet switch WHITE connector into the control unit WHITE plug. 5. Plug the valet switch WHITE connector into the control unit WHITE plug.

Brake Lights (Mandatory)

Brake Lights (Mandatory)
I I
CAUTION: As a safety feature, the unit monitors the brake light to CAUTION: As a safety feature, the unit monitors the brake light to
prevent an unauthorized driver from driving the car and to switch to prevent an unauthorized driver from driving the car and to switch to
normal engine operating condition. For this reason, the YELLOW normal engine operating condition. For this reason, the YELLOW
brake light input wire must be connected and the brake light must be brake light input wire must be connected and the brake light must be
in working condition or the remote start will not operate properly. in working condition or the remote start will not operate properly.
1. Turn the ignition key to the "ON" position, then press the brake pedal and 1. Turn the ignition key to the "ON" position, then press the brake pedal and
make sure the brake light illuminates. make sure the brake light illuminates.
2. Use a voltmeter to find the one wire at the brake light switch (usually 2. Use a voltmeter to find the one wire at the brake light switch (usually
located on the upper brake pedal arm) that shows +12 volts when you located on the upper brake pedal arm) that shows +12 volts when you
press the brake pedal and 0 volts when the brake pedal is not pressed. press the brake pedal and 0 volts when the brake pedal is not pressed.
3. Connect the YELLOW wire to the vehicle brake light switch wire. 3. Connect the YELLOW wire to the vehicle brake light switch wire.

Parking Lights

Parking Lights
1. If the parking lights are positive trigger, connect the RED/WHITE wire to 1. If the parking lights are positive trigger, connect the RED/WHITE wire to
the battery positive (+) terminal through the 20 amp fuse assembly. the battery positive (+) terminal through the 20 amp fuse assembly.
NOTE: Do not connect the RED/WHITE wire to the control unit RED wire. NOTE: Do not connect the RED/WHITE wire to the control unit RED wire.
AviStart 4500 Installation Manual - 0898 Rev. A
Con tin ued on next page. Con tin ued on next page.
7