Cisco DPC User Manual page 79

Configuring Your Wireless Access Point Parameters
Use the Setup Wireless - Basic page to configure your wireless access point (WAP)
parameters, including SSID and channel number.
Note: If you are not familiar with the advanced settings detailed in this section,
contact your service provider before you attempt to change any of the residential
gateway default wireless basic settings.
Click Basic in the Wireless section of the Setup page to access the Setup Wireless -
Basic page.
Setup Wireless - Basic Page
The following illustration is an example of the Setup Wireless - Basic page showing
the factory default settings.
Setup Wireless - Basic Page Description
This section describes the section headings and fields descriptions of the Setup
Wireless - Basic page.
Note: If you make changes in the Setup Wireless - Basic page, click Apply to apply
and save your wireless basic settings.
Field Name
Access Point
Service Set Identifier
(SSID)
4024320 Rev A
How Do I Configure My DOCSIS Residential Gateway?
Description
Allows you to turn the access point on the gateway on or
off
The name assigned to this access point
Note: The factory default for the SSID field should contain
the last 6 digits of the cable modem's MAC address as
found on the label.
79