Modem Problems; Problem; Possible Cause; Usb Device Problems - Fujitsu LifeBook A6010 User Manual

fennec.book Page 50 Thursday, September 7, 2006 11:42 AM
L i f e B o o k A 6 0 0 0 S e r i e s N o t e b o o k - S e c t i o n F i v e

Problem

Modem Problems

Messages about modem Modem operation messages
operation. are generated by whichever
modem application is in use.

USB Device Problems

You have installed a USB The device is not properly
device that your LifeBook installed.
notebook does not recog-
The device may have been
nize, or the device does not
installed while an application
seem to work properly.
was running, so your notebook
is not aware of its installation.
Your device may not have the
correct software driver active.
You may have the wrong I/O
address selected for the device.
Your device and another device
are assigned the same I/O
address.
PC Card/ExpressCard Problems
A card inserted in the card The card is not properly
slot does not work or is inserted.
locking up the system.
The card may have been
inserted while an application
was running, so your notebook
is not aware of its insertion.
Your software may not have
the correct software driver
active.
You may have the wrong I/O
address selected for your card
device.
Your card device and another
device are assigned the same
I/O address.

Power Failures

You turn on your LifeBook The installed primary battery
notebook and nothing is completely discharged, there
seems to happen. is no modular bay battery
installed or there is no Power
adapter (AC or Auto/Airline)
installed.
50

Possible Cause

See your application software documentation for
additional information.
Remove and reinstall the device. (See Device Ports on
page 42 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 25 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Remove and re-insert the card. (See PC Cards/
ExpressCards™ on page 38 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your card documentation to determine the
required I/O address. Change the settings in the
BIOS. (See BIOS Setup Utility on page 25 for more
information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check the Status Indicator Panel to determine the
presence and condition of the batteries. (See Status
Indicator Panel on page 11 for more information)
Install a charged battery or a Power adapter.
Possible Solutions