Memory Problems; Problem; Modem Problems; Parallel, Serial And Usb Device Problems - Fujitsu LifeBook S6000 Manual

L i f e B o o k S 6 0 0 0 N o t e b o o k

Problem

You have installed an
external keyboard or
mouse, and it does not
seem to work.
You have connected an
external keyboard or a
mouse and it seems to be
locking up the system.

Memory Problems

Your Power On screen, or
Main menu of the BIOS
setup utility information,
does not show the correct
amount of installed
memory.

Modem Problems

Messages about modem
operation.
Parallel, Serial, and USB Device Problems
You have installed a parallel
port device, a serial port
device or a USB device.
Your LifeBook notebook
does not recognize the
device, or the device does
not seem to work properly.
58
Possible Cause
Your external device is not
properly installed.
Your operating system
software is not setup with the
correct software driver
for that device.
Your mouse or keyboard is
connected to the wrong PS/2
port on the optional Port
Replicator.
Your operating system
software is not setup with
the correct software driver
for that device.
Your system has crashed.
Your memory upgrade module
is not properly installed.
You have a memory failure.
Messages about modem
operation are generated by
whichever modem application
is in use.
The device is not
properly installed.
The device may have been
installed while an application
was running, so your notebook
is not aware of its installation.
Your device may not have the
correct software driver active.
You may have the wrong I/O
address selected for your
device.
Your device and another device
are assigned the same I/O
address.
Parallel port is set to output
only.
Possible Solutions
Re-install your device. (See Device Ports on page 49
for more information)
Check your device and operating system docu-
mentation and activate the proper driver.
Plug the mouse into the PS/2 Mouse port and
the external keyboard or numeric key pad into the
PS/2 Keyboard port. (See PS/2 Port on page 50 for
more information)
Check your device and operating system
documentation and activate the proper driver.
Try to restart your notebook. I
Remove and re-install your memory upgrade
module. (See Memory Upgrade Module on page 45
for more information)
Check for Power On Self Test (POST) messages.
(See Power On Self Test Messages on page 64 for more
information)
See your application software documentation for
additional information.
Remove and re-install the device. (See Device Ports
on page 49 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 29 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check parallel port setting in the BIOS and set to
bi-directional or ECP.