Advertisement
Cisco LRE 48 POTS Splitter
The Cisco LRE 48 POTS Splitter is a high-density, low-cost device that is ideal for
building deployments where the PBX system is on-site and POTS traffic must coexist
over the same copper wiring as LRE traffic. Unlike "splitterless" building broadband
network solutions, the Cisco LRE 48 POTS Splitter ships as a separate, compact form
factor to ensure that POTS service is separate, and never compromised by LRE switch
reconfigurations or downtime.
The Cisco LRE 48 POTS Splitter supports 48 ports in a 1RU form factor. Each splitter
has six RJ-21 connectors-two each for connectivity to the patch panel, the LRE
switch(es), and the on-site PBX system.
When to Sell
Sell This Product
When a Customer Needs These Features
Catalyst 2924 LRE XL
• 24 Long-Reach Ethernet ports and four 10/100 Ethernet ports for higher density deployments
• Ethernet over existing Category 1/2/3 wiring at speeds from 5 to 15 Mbps (full duplex) and distances up
Catalyst 2912 LRE XL
• 12 LRE ports and four 10/100 Ethernet ports
• Ethernet over existing Category 1/2/3 wiring at speeds from 5 to 15 Mbps (full duplex) and distances up
Cisco 575 LRE CPE Device
• A device to bridge LRE and Ethernet connections
• Support for POTS phone and high-speed data connections
Cisco LRE 48 POTS
• Supports 48 LRE ports with 6 RJ-21 connectors
Splitter
• Required only where LRE traffic must co-exist with POTS traffic on same wire
Key Features
• Quality of Service—802.1p QoS support provides high and low priority queuing
on a per-port basis. Layer 3 QoS support-including DiffServe and
application-based queuing—when aggregated by a Layer 3 switch.
• Scalability—Up to 15-Mbps symmetric performance over single-pair wiring; Fast
EtherChannel port aggregation.
• Security—802.1Q port-based virtual local-area network (VLAN) support; Cisco
private VLAN access, assuring port security without requiring a VLAN per port;
Access control list (ACL) security when a LRE switch is aggregated by a Cisco
Layer 3 10/100 Ethernet switch.
• Network Management—Cisco Switch Clustering technology and the advanced,
Web-based Cisco Cluster Management Suite (CMS) software deliver easy-to-use
configuration and ongoing monitoring and management of up to 16 switches. This
software is embedded in the switches and delivers remote management of
clustered switches and connected CPE devices through a single IP address.
Competitive Products
• Elastic Networks: BitStorm solution (Etherloop)
• Tut: Expresso (HPNA)
Cisco Long Reach Ethernet Solution
7-34
to 5,000 feet
to 5,000 feet
Chapter 7
Broadband and Dial Access Products
• Extreme: Alpine FM-8Vi (Ethernet over VDSL)
Advertisement
