Object Detection Systems; Ending Cruise Control; Erasing Speed Memory; Ultrasonic Parking Assist - GMC 2012 Yukon/Yukon XL Owner's Manual

Ending Cruise Control

There are three ways to end cruise
control:
To disengage cruise control,
step lightly on the brake pedal.
Press the on the steering
wheel.
To turn off the cruise control,
press on the steering wheel.

Erasing Speed Memory

The cruise control set speed is
erased from memory by pressing
the button or if the ignition is
turned off.
Object Detection
Systems

Ultrasonic Parking Assist

If available, the Ultrasonic Rear
Parking Assist (URPA) system uses
sensors on the rear bumper to
assist with parking and avoiding
objects while in R (Reverse).
WARNING
The URPA system does not
detect pedestrians, bicyclists,
animals, or any other objects
located below the bumper or that
are too close or too far from the
vehicle. To prevent injury, death,
or vehicle damage, even with
URPA, always check behind the
vehicle and check all mirrors
before backing.
Driving and Operating
How the System Works
URPA comes on automatically
when the shift lever is moved into
R (Reverse). A single tone sounds
to indicate the system is working.
URPA operates only at speeds less
than 8 km/h (5 mph).
An obstacle is indicated by
audible beeps. The time between
the beeps gets shorter as the
vehicle approaches the obstacle.
A continuous tone is heard when
the distance is less than
30 cm (12 in).
To be detected, objects must be at
least 25 cm (10 in) off the ground
and below liftgate level. Objects
must also be within 2.5 m (8 ft) from
the rear bumper. This distance may
be less during warmer or humid
weather.
9-53