Pads - GE ASD06 Owner's Manual & Installation Instructions

Aboutthe controlsontheair conditioner-models with touchpads.
Features and appearance will varg.
Low Med High 4 CIRCULAIRE ENERGY
Fan FaR Fan _ SAVEROn
On
Fan
Only
0_
POWE_
@
0
0
0
0
0
Air ConditionerControls RemoteControl
O ON/OFF
Turns air conditioner on and off.
@ Display
O MODE
Use to set the air conditioner to COOL (}1" F AN.
O TIMER
ON-When the air conditioner is off, it can be
_t to aulomatically come on in 1 to 24 hom,'s
at its pre'dous setting. Each touch will set the
time in hem ,'s.
O Increase •/Decrease • Pads
Use to set temperature
when in COOL mode.
FAN
Use to set the fan speed at LOW,MED or HIGH.
CIRCULAIRE O
Turn on to pro'dde continuous side-to-side
air circulation.
For fixed side-to-side air direction, turn ON
until the desired air direction is obtained,
then mrn it OFF.
O ENERGYSAVER-Conm}ls the Pan.
ON-1_aefan and compressor cycle on and off.
This results in wider variations of room
temperature and humidity-. Normally used
when the room is unoccupied. Note: The fan
will continue to run for a short time after the
compressorcycles off.
0FF--The fan runs all the time, while the
compressor cycles on and off.
This switch must be set at OFF in order to use
the fan _tting,'s (on the mode conu'ol).
0FF-When the air conditioner is on, it can be
_t to automatically turn offin 1 Io 24 hours.
Each touch will set the time in hem ,'s.
To cancel flae timer, press the TIMERpad
until the display time disappear.
SLEEP
Press to ,setthe air conditioner to tun for
8 hours before it automatically shuts off,
When the SLEEPpad is pres_d, SLEEP
scrolls across the display- for approximately
15 seconds, then shows the time remaining.
One hour afmr the sleep timer is _t, the _t
temperature will automatically increase 1°F.
To cancel flae sleep mode, pre_s the SLEEP
pad a second time.
Note:Thesloop timer will be cancelled if the
TIMER,ENERGY SAVER or MODEpad is pressed.
Remote Control Signal Receiver
4
Remote Control
% To ensure proper operation, aim the
remote control at flae signal receiver
on the air conditioner.
% The remote control signal has a I_ange of
up to 21 feet.
_ Make sure nothing is between 1he air
conditioner and the remote con_ol
flaat could block Ilae signal.
_ Make sure batmries are fresh and installed
correctly_:ee
the Care and Cleaning section.