Table of Contents
Advertisement
Steps
in disassembly
t,Turn off the air conditioner,and remove
the plug from the power sucket
Upon turning off the air conditioner, leave
it idle for at least 30 minutes; the
disassembly can then be implemented
after the system has been stabilized.
%
2.Use a Philips-head screw driver to
remove the cover.
3Disconnect the electrical connector
by pressing clip holders.
4,Remove the metal holding brackets
5.Remove the insulatingfoam around
the upper connector.
• This procedure should be carried out by
a professional person to avoid expensive
mistakes.
6.Use the 2 spanners
provided
to
disconnect
the 2 pipes,
Make sure the tubes and connectors
are kept level while disconnecting to
avoid coolant leaking.
7,Screw the protective caps onto the
ends after disconnection of each pipe
8.Separate the clamping tie on the black
Water pipe, Gradually release the water
pipe and place your finger over the end
to prevent water in the tube coming out.
Have a conta_,ler ready to collect any
excess water from the tube.
Steps
in connecting
• Always remember to keep the
connecting pipes level with
the connecing point when
re-assembllog
• When re-connecting the uni[ follow the
above steps in reverse.
• Use your fingers to connect the threads
and then t_hten with the spanners
provided
• After connection please use soap suds
to check for leaks in the coolant pipe.
Please remember, this procedure must be
followed each time.
J
MODEL/MODELO:
0E77126
Hide quick links:
Advertisement
Table of Contents
