Oven Light Replacement - GE JGBP29 Owner's Manual And Installation Instructions

Care and cleaning of the range.
Pull the knob straight off the stem.
Lower Control Panel (Front Manifold Panel) and Knobs
It'sa good idea to wipe the control panel after
each use of the oven. Use a damp cloth to
clean or rinse. For cleaning, use mild soap and
water or a 50/50 solution of vinegar and water.
For rinsing, use clean water. Polishdry with a
soft cloth.
Do not use abrasive cleansers, strong liquid
cleaners, plastic scouring pads or oven cleaners
on the control panel-they will damage the
finish.
Do not bend knobs by pulling them up or down
or by hanging a towel or other such loads. This
can damage the gas valve shaft.
The control knobs may be removed for easier
cleaning.
Make sure the knobs are in the Offpositions
and pull them straight off the stems for
cleaning.
The knobs can be cleaned in a dishwasher or
they may also be washed with soap and water.
Make sure the insides of the knobs are dry
before replacing.
Replacethe knobs in the Off position to ensure
proper placement.
Metal parts can be cleaned with soap and
water. Do not use steel wool, abrasives,
ammonia, acids or commercial oven cleaners.
Dry with a soft cloth.
Oven Racks
Clean the racks with an abrasive cleanser or
scouring pod. After cleaning, rinse the racks
with clean water and dry with a clean cloth.
If the racks ever become hard to slide,wipe
the rack edges or oven rack supports with
vegetable oil.
NOTE:Take the racks out of the oven beforeyou
begin the self-clean cycle or they may discolor.
Heavy-Duty Oven Racks (on some models)
Clean the racks with an abrasive cleanser.
The oven racks may be cleaned in the self-
cleaning oven. However, the racks will darken in
color, lose their luster and become hard to slide
if cleaned during the self-cleaning cycle.
To make the racks slide more easily,apply a
small amount of vegetable oil or cooking oil to
a paper towel and wipe the edges of the oven
racks with the paper towel.
Wire cover holder.
Oven Light Replacement
CAUTION: Before replacing your
oven light bulb, disconnect the electrical power
to the range at the main fuse or circuit breaker
panel. Be sure to let the light cover and bulb cool
completely.
The oven light bulb is covered with a removable
glass cover that is held in place with a
bail-shaped wire. Removethe oven door, if
desired, to reach cover easily.
To remove:
Hold a hand under the cover so it doesn't
ii i
fall when released. With fingers of the
same hand, firmly push back the wire
cover holder. Lift off the cover.
[] Do not touch hot bulb with a wet cloth.
Replace bulb with a 40-watt household
appliance bulb.
To replace coven
[] Place it into the groove of the light
receptacle. Pull the wire forward to the
center of the cover until it snaps into place.
When in place, the wire holds the cover
firmly. Be certain the wire is in the
depression in the center of the cover.
Connect electrical power to the range.
3 2 Do not remove any screws to remove the
cover.