Assemble The Flex Door; Assemble The Freezer Drawer; Disassemble The Freezer Drawer; Leveling The Refrigerator - Samsung RF4289HARS User Manual

ASSEMBLE THE FLEx DOOR

To reattach the flex door after you have moved the fridge
to its final location, assemble parts in reverse order.
DISASSEMBLE THE FREEzER
DRAWER
1. Take out the upper
drawer by lifting it up.
2. Remove the tilting pocket ( 1 ) by pulling both
support guards ( 2 ) aside. And take out both
support guards by pulling them aside.
3. Take out the lower
basket ( 3 ) by lifting
the basket up from
the rail system.
4. Remove 4 hex head bolts
from both sides with a socket
wrench (10mm).
5. Lift up the freezer door from
the rails.

ASSEMBLE THE FREEzER DRAWER

To reattach the drawer after you have moved the fridge
to its final location, assemble parts in reverse order.

LEvELING THE REFRIGERATOR

Make sure the refrigerator is level so that you can make
final adjustments. Use a level to test if the refigerator
is level both side to side and back to front. If the
refrigerator is not level, it will not be possible to get
the doors perfectly even, which may cause moisture
condensation and increased energy bills. Below is an
example of how to level the refrigerator if the left side of
the refrigerator is lower than the right side.
How to adjust the level
1. Open the freezer drawer
and remove the lower
basket. (See to page 9)
2. Remove the two screws
( 1 ) attached to the front
leg cover ( 2 ) with a
Philips screwdriver (+).
1
3. Remove the front leg
2
cover ( 2 ) by lifting the
bottom part of the front
leg cover up and pulling it out.
3
4. Insert a flat-blade screwdriver (-) into a notch on
the left control lever, and turn it count clockwise to
level the refrigerator.
(You turn the lever clockwise to lower the
refrigerator and counterclockwise to raise it.)
Flat-Blade Screwdriver(-)
cAuTION
control Lever
Both control levers must be touching the floor
to avoid possible personal injury or property
damage because of tipping.
2
1
setting up _09