Visca Device Setting Command - Sony FCB-IX45C Technical Manual

VISCA Device Setting
Command
Before starting control of the FCB camera, be sure to
send the Address command and the IF_Clear
command using the broadcast function.
For VISCA Network Administration
● Address
Sets an address of a peripheral device. Use when
initializing the network and when receiving the
network change message indicated below.
● Network Change
Sent from the peripheral device to the controller
when a device is removed from or added to the
network. The address must be re-set when this
message is received.
Packet
Address 88 30 01 FF
Network Change X0 38 FF
X = 9 to F: FCB camera address + 8
VISCA Interface Command
● IF_Clear
Clears the command buffers in the FCB camera and
cancels the command currently being executed.
Command Packet Reply Packet Note
IF_Clear 8X 01 00 01FF
IF_Clear (broadcast) 88 01 00 01 FF
X = 1 to 7: FCB camera address (For inquiry packet)
X = 9 to F: FCB camera address +8 (For reply packet)
Note
Always broadcasted.
X0 50 FF
88 01 00 01 FF
VISCA Interface and Inquiry
● IF_DeviceTypeInq
Returns information on the VISCA interface.
Inquiry Inquiry Packet Reply Packet
IF_DeviceTypeInq 8X 09 00 02 FF Y0 50 GG GG HH GGGG = Vender ID
X = 1 to 7: FCB camera address (For inquiry packet)
X = 9 to F: FCB camera address +8 (For reply packet)
Command List
Description
HH JJ JJ KK FF (0020: Sony)
HHHH = Model ID
043C=FCB-IX47C
043D=FCB-IX47CP
043E=FCB-IX45C
043F=FCB-IX45CP
JJJJ = ROM revision
KK = Maximum socket # (02)
39