Monitoring The Camera Image; Using The Msu-900/950; Connections - Sony F23 Operation Manual

Monitoring the Camera Image

Settings on this camera
Set RM VIDEO to VBS on the <MONITOR OUTPUT>
page of the USER (OPERATION) menu.
Settings on the RM-B750
Press the MONITOR button. The camera image will be
displayed on the display of the RM-B750.
VBS signals are fed to an external monitor if connected via
the MONITOR connector of the RM-B750.
88

Using the MSU-900/950

Using the MSU-900/950
You can adjust this camera from the MSU-900/950 Master
Setup Unit via an Ethernet cable.
You can use either Bridge mode to control a camera from
an exclusive MSU-900/950 or Multi mode to control
multiple cameras from one MSU-900/950 or from multiple
remote controllers, including the MSU-900/950 via a
HUB.

Connections

Bridge mode
For using one camera on an Ethernet network.
Using an Ethernet cable, connect the MSU-900/950 to the
(network) connector of this camera.
You may use the remote cable connection simultaneously.
Example
1 2 3
FILTER
2 1 1/4 ND CLEAR
ND 4 3 1/16ND 1/64ND
5 CAP
A B 3200K 5600K
CC D C 6300K 4300K
E 1/2 ND
ff T
1.6 LOCK VF MENU/DISPLAY CANCEL/STATUS
2
60 2.8
4
30 5.6
20
8
15 11
12
16
10
8 CL RUN
7
4
6
5.6 AUTO
5 BLK REMOTE
4.6 BAL PAGE SET
PRO
REMOTE
RM-B150
Multi (MCS) mode
Connect the Ethernet cable connected to the
connector of this camera to the HUB.
You may use the remote cable connections simultaneously.
Notes
• Remote cable connections will be invalid if the master
unit is not connected to the same network.
• If the master-specified MSU-900/950 is off, all the
network/remote communications are disabled.
• Do not connect devices having the same IP address to the
network.
• Do not connect cameras having the same ID number to
the network. Communications would be disabled on
both cameras.
MSU-900/950
(network)