PREPARATION
FRONT PANEL CONTROLS
A
This is a simplified representation of the front panel. Here shown may be somewhat different from your TV.
A
If your product has a protection film attached, remove the film and then wipe the product with a polishing
cloth.
Plasma TV Models: 50PF9 * , 60PF9 *
SWIVEL STAND
After installing the TV, you can adjust the TV set
manually to the left or right direction by 20 degrees
to suit your viewing position.
4
INPUT
MENU
Power/Standby Indicator
• illuminates red in standby mode.
POWER Button
(Only
)
60PF9 *
Remote Control Sensor
INPUT
MENU
OK
VOL
OK
VOL
OK Button
MENU Button
INPUT Button
VOLUME Buttons
!
NOTE
G G
Before adjusting the angle, you must
remove the cable management and
loosen (to the left) the shaft bolt on the
middle of stand's back. And when stand
be level with TV, you must close (to the
right) the shaft bolt to set the hole.
PR
PR
PROGRAMME Buttons