LG 37LY95 Owner's Manual page 28

EXTERNAL EQUIPMENT SETUP
!
NOTE
To enjoy vivid picture and sound, connect a PC to
G
the set.
Avoid keeping a fixed image on the set's screen for
G
a long period of time. The fixed image may become
permanently imprinted on the screen; use a screen
saver when possible.
Connect PC to the RGB (PC) or HDMI IN (or
G
HDMI/DVI IN) port of the set; change the resolu-
tion output of PC accordingly.
There might be noise according to some resolution,
G
vertical pattern, contrast or brightness in PC mode.
Change the PC mode into another resolution or
change the refresh rate into another rate or adjust
the brightness and contrast on the menu until the
picture is clean. If the refresh rate of the PC graph-
ic card can not be changed, change the PC graph-
ic card or consult it to the manufacturer of the PC
graphic card.
The synchronization input waveform for Horizontal
G
and Vertical frequencies are separate.
We recommend using 1920x1080 (Reduced
G
Blanking Timing), 60Hz for the PC mode, they pro-
vide the best picture quality.
In Plasma TV models, we recommend using
G
1024x768, 60Hz for the PC mode, they provide
the best picture quality.
Connect the signal cable from the monitor output
G
port of the PC to the RGB (PC) port of the set or
the signal cable from the HDMI output port of the
26
PC to the HDMI IN (or HDMI/DVI IN) port on the
set.
Connect the audio cable from the PC to the Audio
G
input on the set. (Audio cables are not included
with the set).
If using a sound card, adjust PC sound as required.
G
This set uses a VESA Plug and Play Solution. The
G
set provides EDID data to the PC system with a
DDC protocol. The PC adjusts automatically when
using this set.
DDC protocol is preset for RGB (Analog RGB),
G
HDMI (Digital RGB) mode.
If required, adjust the settings for Plug and Play
G
functionally.
If graphic card on the PC does not output analog
G
and digital RGB simultaneously, connect only one
of either RGB or HDMI IN (or HDMI/DVI IN) to
display the PC on the set.
If graphic card on the PC does output analog and
G
digital RGB simultaneously, set the set to either
RGB or HDMI; (the other mode is set to Plug and
Play automatically by the set.)
DOS mode may not work depending on video card
G
if you use a HDMI to DVI cable.
When you use too long RGB-PC cable, there might
G
be a noise on the screen. We recommend using
under 5m of the cable. It provides the best picture
quality.