Sony HT-CT260H Operating Instructions Manual page 17

Removing the stands
When the Sound Bar is to be placed
tilting upward or on a wall, remove the
2 stands at the bottom of the Sound
Bar, as shown below.
Stand
Installing the Sound Bar on
a wall
You can install the Sound Bar on the
wall.
Notes
 Use screws that are suitable for the wall
material and strength. As a plaster
board wall is especially fragile, attach
the screws securely to a wall beam.
Install the Sound Bar on a vertical and
flat reinforced area of the wall.

Be sure to subcontract the installation
to Sony dealers or licensed contractors
and pay special attention to safety
during the installation.
 Sony is not responsible for accidents or
damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied)
that are suitable for the holes on
the back of the Sound Bar.
More than 30 mm (1 1/4 inches)
Hole on the back of the Sound Bar
2
Fasten the screws to the wall.
The screws should protrude 11 to
12 mm (approx. 15/32 inches).
11 to 12 mm
(approx.
15/32 inches)
4 mm
(3/16 inches)
5 mm
(7/32 inches)
10 mm
(13/32 inches)
592 mm
(23 5/16 inches)
continued
17
US