Turning Off The Power - Sony VPL-SW525 Operating Instructions Manual

1 Press the KEYSTONE key on the remote
commander or select V Keystone in the
Installation menu.
2 Use the V/v/B/b keys to set the value. The
higher the value, narrower the top of the
projected image. The lower the value, the
narrower the bottom.
Notes
• Since the Keystone adjustment is an
electronic correction, the image may be
deteriorated.
• Depending on the position adjusted with the
lens shift feature, the aspect ratio of the
image may change from the original or
projected image may be distorted with
Keystone adjustment.
Displaying a pattern for adjusting an image
You can display a pattern for adjusting the projected image with the PATTERN key on the
remote commander. Press the PATTERN key again to restore the previous image.
Automatically adjusts Phase, Pitch and Shift of projected image while a
signal is input from a computer (APA (Auto Pixel Alignment))
Press the APA key on the remote commander. Press again to cancel adjusting during the setting.
You can also set APA in the Screen Menu (page 19). If Smart APA in the Function menu is set
to "On", executes APA automatically when a signal is input (page 22).
Shrinking an image that exceeds the screen size
1 Select "Digital Shrink" in "Screen Fitting" to display adjusting menu.
2 Adjust the value by the V/v/B/b keys. The higher the value, the smaller the image becomes.
Note
Since the Digital shrink is an electronic correction, the image may be deteriorated.

Turning Off the Power

1
Press the ?/1 key on the unit or the remote commander.
The projector starts shutdown and turns off. If you press the ?/1 key within 10 seconds
again, shutdown is cancelled.
2
Unplug the AC power cord from the wall outlet.
To turn off without displaying confirmation message
Press and hold the
16
Projecting an Image
?/1
key on the unit for a few seconds (page 37).
Increase the number
towards plus
Increase the number
towards minus