Sony SRX-T105 Brochure page 8

Operational Versatility
Option slots
LKRI-001 LKRI-002
Analog Input Board HD-SDI (4:2:2) Input Board
Input Signal Flexibility
To increase the configuration flexibility of the
SRX-T110 and SRX-T105, slots are available to
accommodate four different optional boards that
connect to various types of signal formats.
The SRX-T110 and SRX-T105 are pre-installed with
an LKRI-005 HDCP DVI Board, which can accept
DVI signals and provides a digital copy protection
capability. In addition to the standard HDCP DVI
input, three slots are available for the installation
of optional boards. This allows simultaneous
accommodation of up to four input/interface
boards in the side panel of the projector. Users
can select from single, dual, and quad screen
modes, and assign the appropriate signal board
to each quadrant.
Signal Chart for the LKRI-005
Signal Resolution
1024 x 768P (XGA)
1280 x 960P (Quad-VGA)
1280 x 720P
1280 x 720P
1280 x 1024P (SXGA)
1400 x 1050P (SXGA+)
1600 x 1200P (UXGA)
1920 x 1200P (WUXGA)
1920 x 1080P
1920 x 1080P
1920 x 1080P
2048 x 1080P
2048 x 1080P
2048 x 1080P
8
LKRI-003
Dual-link HD-SDI Input Board
The LKRI-001 Analog Input Board utilizes 5 BNC
•
connectors that can accept 0.7 volt analog
signal levels as RGBS, RGB sync on G, RGBHV, or
YUV formats.
The LKRI-002 HD-SDI (4:2:2) Input Board can
•
accept both SMPTE 259M SD digital 525/625
line video and SMPTE 292M 1080 4:2:2 Y . Pb . Pr
serial picture data. Switching is automatic by
detection of the input signal frequency.
• The LKRI-003 Dual-link HD-SDI Input Board can
accept any of the following signals: SMPTE
372M dual-link HD-SDI (4:4:4), SMPTE 292M HD-
SDI (4:2:2), dual-link DC-SDI (RGB 4:4:4), DC-SDI
(YPbPr 4:2:2), or 12-bit (X'Y'Z' 4:4:4) signals. With
four LKRI-003 boards, the SRX-T110 and SRX-T105
can project 4096 x 2160 4K images.
• The LKRI-005 HDCP DVI Board can accept DVI
signals up to 2048 x 1080P and offers a digital
copy protection capability compliant with the
fV (Hz) HDCP
HDCP specification to 1920 x 1080P and 1280 x
60 No
720P signals.
60 No
60 Yes
Installation Flexibility
50 Yes
60 No
The SRX-T110 and SRX-T105 can be tilted 90
60 No
degrees upward or downward. In addition, they
60 No
can turn projected images upside down. This
60 No
flexibility allows the projectors to be used in several
60 Yes
different ways, including a rear projection system.
50 Yes
To aid effective cooling at 90-degree tilt
24 Yes
installation, an optional LKRA-001 exhaust duct
60 No
adaptor is required, which allows the projectors
48 No
to be easily connected to a common 8-inch-type
24 No
duct system.
LKRI-005
HDCP DVI Board