Installation Requirements; Tools And Parts - Maytag MEDB700BW Installation Manual

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed:
Flat-blade screwdriver
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Wire stripper (direct wire
installations)
Caulking gun and
compound (for installing
new exhaust vent)
1/4" nut driver
(recommended)
Pliers
#2 Phillips screwdriver
Level
Vent clamps
Tin snips (new vent
installations)
Tape measure
Parts supplied (all models):
Leveling legs (4) for models
with riser
Parts supplied (steam models):
"Y" connector
5' (1.52 m) inlet hose
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed:
(Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Mobile home installations require metal exhuast system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the "Assistance
or Service" section in your "Use and Care Guide."
Optional Equipment:
(Not supplied with dryer)
Refer to your "Use and Care Guide" for information about
accessories available for your dryer.
Leveling legs (4) for models
without riser
Short inlet hose
Rubber washer
3