Setup And Configuration Overview - Intel Precision M2400 Administrator's Manual

Back to Contents Page

Setup and Configuration Overview

The following is a list of important terms related to the Intel® AMT setup and configuration.
Setup and configuration — The process that populates the Intel AMT-managed computer with usernames,
passwords, and network parameters that enable the computer to be administered remotely.
Provisioning — The act of setting up and configuring Intel AMT.
Configuration service — A third-party application that completes the Intel AMT provisioning.
Intel AMT WebGUI — A Web browser-based interface for limited remote computer management.
You must set up and configure Intel AMT in a computer before using it. Intel AMT setup readies the computer for Intel AMT
mode and enables network connectivity. This setup is generally performed only once in the lifetime of a computer. When Intel
AMT is enabled, it can be discovered by management software over a network.
Once Intel AMT is set up in Enterprise mode, it is ready to initiate configuration of its own capabilities. When all required
network elements are available, simply connect the computer to a power source and the network, and Intel AMT automatically
initiates its own configuration. The configuration service (a third-party application) completes the process for you. Intel AMT is
then ready for remote management. This configuration typically takes only a few seconds. When Intel AMT is set up and
configured, you can reconfigure the technology as needed for your business environment.
Once Intel AMT is set up in SMB mode, the computer does not have to initiate any configuration across the network. It is set
up manually and is ready to use with the Intel AMT Web GUI.
Intel AMT Setup and Configuration States
The act of setting up and configuring Intel AMT is also known as provisioning. An Intel AMT capable computer can be in one
of three setup and configuration states:
The factory-default state is a fully unconfigured state in which security credentials are not yet established and Intel
AMT capabilities are not yet available to management applications. In the factory-default state, Intel AMT has the
factory-defined settings.
The setup state is a partially configured state in which Intel AMT has been set up with initial networking and transport
layer security (TLS) information: an initial administrator password, the provisioning passphrase (PPS), and the
provisioning identifier (PID). When Intel AMT has been set up, Intel AMT is ready to receive enterprise configuration
settings from a configuration service.
The provisioned state is a fully configured state in which the Intel Management Engine (ME) has been configured with
power options, and Intel AMT has been configured with its security settings, certificates, and the settings that activate
the Intel AMT capabilities. When Intel AMT has been configured, the capabilities are ready to interact with management
applications.
Back to Contents Page