Dell Powerconnect W-ClearPass Hardware Appliances Quick Start Manual page 6

Required Item
Hostname (Policy Manager
server)
Management Port IP Address
Management Port Subnet Mask
Management Port Gateway
Data Port IP Address (optional)
Data Port Gateway (optional)
Data Port Subnet Mask
(optional)
Primary DNS
Secondary DNS
NTP Server (optional)
To set up the Policy Manager appliance:
1. Connect and power on.
Using the null modem cable provided, connect a serial port on the appliance to a terminal, then connect power
and switch on. The appliance immediately becomes available for configuration.
Use the following parameters for the serial port connection:
Bit Rate: 9600
l
Data Bits: 8
l
Parity: None
l
Stop Bits: 1
l
Flow Control: None
l
2. Login.
Later, you will create a unique appliance/cluster administration password. For now, use the preconfigured
credentials:
login: appadmin
password: eTIPS123
This starts the Policy Manager Configuration Wizard.
3. Configure the appliance.
Replace the bolded placeholder entries in the following illustration with your local information:
Enter hostname: hyperion.us.arubanetworks.com
Enter Management Port IP Address: 192.168.5.10
Enter Management Port Subnet Mask: 255.255.255.0
Enter Management Port Gateway: 192.168.5.1
Enter Data Port IP Address: 192.168.7.55
Enter Data Port Subnet Mask: 255.255.255.0
Enter Data Port Gateway: 192.168.7.1
Enter Primary DNS: 198.168.5.3
6
Item Information
Data Port IP Address must not be in the same subnet as
the Management Port IP Address
Dell Networking W-ClearPass Policy Manager 6.0 | Quick Start Guide