Advertisement
5. Attach the connector plate and connectors to the base plate as follows:
a. Select the connector plate that matches the existing connectors that were attached to junction box
face plate.
b. Attach the selected connector plate by sliding it over the opening in the bottom of the base. (See
Figure
c. Once the connector plate is secure, attach the connectors to the openings in the plate. Any empty
opening should be filled using one of the connector plate blanks. (See
Once the connectors and connector plate blanks are in place, reposition the cables so they are routed below the
screw post, as shown in
N O T E
Figure 6 Attaching connector plate and connectors (AP not shown)
6. Position the AP's antennas so they suit your deployment scenario. If you plan on keeping the antennas
hidden in the enclosure, skip this step and proceed to
AP-120-MNT-WJ Access Point Enclosure
6).
Figure 8
and
Figure
| Installation Guide
9.
step
8.
Figure
6)
5
Advertisement
