Advertisement
Installing the AP Enclosure
To install the AP enclosure:
For ceiling mounted APs, skip
N O T E
1. Attach the base plate as follows:
a. Remove the cover plate from an installed junction box
Figure 1 Removing the installed cover plate
b. Snap the cable connectors out of the removed cover plate and set the cover plate aside. Identify the
Ethernet cable that will be connected to the AP-121 or AP-125. The Ethernet cable must have a male
RJ-45 connector.
c. Attach the enclosure base plate to the junction box using the screws from the removed cover plate
(Figure
d. Skip step 2 and proceed to step 3.
Figure 2 Attaching the base plate
2
step 1
and proceed to
2).
step 2
(Figure
1). Save the screws.
AP-120-MNT-WJ Access Point Enclosure
| Installation Guide
Advertisement
