Advertisement
2. To install the AP enclosure on a ceiling rail:
a. Pull the necessary cables through a prepared hole in the ceiling tile near where the AP will be placed.
The prepared hole must line up with the cable pass-through in the base plate.
b. (Optional) if the ceiling rail is 9/16", install the ceiling rail adapter
c. Hold the enclosure base next to the ceiling rail with the ceiling rail at approximately a 30-degree
angle to the ceiling tile rail
d. Rotate the enclosure base clockwise until the device clicks into place on the ceiling rail.
Figure 3 Installing the AP on a ceiling rail
3. Connect the Ethernet cable to Ethernet port 0 on the AP. Hold the unused cables down and to the right
of the screw post as you continue with the next step.
4. Attach the AP to the mounted base plate as follows:
a. Position the antennas on the AP along the sides of the unit.
b. Locate the mounting posts on the base plate and the mounting holes on the AP
Figure 4 Preparing to attach the AP
Mounting Posts
AP-120-MNT-WJ Access Point Enclosure
(Figure
Ceiling tile rail
Installing
9/16" Rail Adapter
| Installation Guide
3).
Align tabs
with rail
(Figure
3).
Rotate AP
until it clicks
into place
Ceiling tile
(Figure
4).
Mounting Holes
3
Advertisement
