Usb Mode - Haier L32R3 User Manual

Vertical Pos.: Vertical position of picture can be
adjusted in this item.
Clock: This is used for adjusting H Position and V
Position as well as relative parameters in PC modes.
Phase : This is used for adjusting the phase of pixel clock
in PC mode.
Quick Menu
This function includes some usual oprations about
PICTURE,SOUND,SAP,SLEEP TIME,Aspect Ratio and
BACKLIGHT.
PICTURE
SOUND
SAP
SLEEP
ASPECT RATIO
BACKLIGHT

USB MODE

Note
The diagrams in the following section are
schematic and only for your reference. Please see
the actual product if necessary.
TO USE THE USB DEVICE
Supported file formats:
• Photo: *.jpg,*.bmp, ect;
• Music: *.mp3,*.wma, ect;
• Movie: *.AVI,*.mpg,*.DAT,*.TS,*.MOV,*.mp4,*.VOB;
• TEXT: *.txt
Note
Due to the particularity of file coding, some files
Q.MENU
Standard
Standard
Mono
Off
Full Screen
100
Close
may be unable to read.
The USB Movie player can surpport codes as
MPEG2, MPEG2_HD,MPEG4,MPEG4_HD,H.264.
when its coding doesn't include in the codes
upwards.
Supported equipment:
Support the equipment that supports Mass
Storage Protocol and whose file system is FAT32,
such as some USB disks and mobile harddisks.
If USB equipment could not be identified due
to unsupported file system, please format the
equipment to the above-mentioned file system.
To achieve smooth playing, ensure the following:
• The file code rate should be lower than 300KB/S;
• Due to the limitation of USB signal transmission
distance, it is recommended not to use USB patch
cord, in case of using the cord, make sure that its
length is not over 1m;
• Use high-speed USB equipment in conformity
with USB2.0 full speed Interface Standard; If USB
equipment in conformity with USB1.1 full speed
Interface Standard is used, the playing may be
unsmooth.
When connecting/removing the USB
device
Press INPUT on the remote control unit to select
USB option.
Insert USB equipment into corresponding USB
interface 2s after starting the system.
After entering the system menu, press
remote control unit to select the require USB files,
press OK button to confirm the selection and enter
the file list relative to the selection.
Press / on the remote control unit to select the
required file, press ENTER button to enter the selected
file.
To exit the streaming media playing system and
watch a TV program, you must press EXIT button to
return to the streaming media main menu at first (to
protect equipment), and then press INPUT to select
AIR or Cable to return to the TV mode.
Note
TV LCD-TFT Owner's Manual
Operation
/ on the
EN-16