Advertisement
Adjust Menu
The TV can be used as a display, and you may adjust relevant settings. The operating
method of various menus is the same as that described for TV signal. The following are
operating methods that different from that for TV signal.
When the TV is used as a display, you may set and
adjust its picture effect by the following steps.
Press SOURCE to switch the signal input to PC mode.
1. Press MENU to display the screen main menu, and
/
then press
to select the Adjust menu as shown in
the right figure.
/
2. Press
to select the option to be adjusted.
/
3. Press
to adjust it.
Aspect Ratio
Press this key to select the screen display proportion.
Auto Adjust
This is used to reset the default setting parameters.
Clock
This is used for adjusting H Position and V Position as
well as relative parameters in PC modes.
Phase
This is used for adjusting the phase of pixel clock in PC
mode.
Adjust
Vertical and Horizontal position of picture can be
adjusted in this item.
Precautions:
1. When making H-Size, V-Size, H-Position or V-Position
adjustment, there sometimes may be abnormalities in
case of a large adjustment range, which is not a fault but
for the signal sync out of range, and the picture will
become normal by reverse adjustment.
2. In PC mode, there are only two aspect ratios (4:3, full
screen) available.
3. There will be a display proportion of "Dot By Dot" when
the singal is 50Hz in the source of YPbPr or HDMI.This
proportion is for Full-HD panel test in factory.Plseae do
not use this proportion,otherwise the display will be
distortionary.
menu
OK
OK
Advertisement
