Usb Device Problems; Pc Card Problems; Power Failures - Fujitsu LifeBook T4210 User Manual

L i f e B o o k T 4 2 0 0 S e r i e s T a b l e t P C - S e c t i o n F i v e
Problem
Modem does not appear to
work.

USB Device Problems

You have installed a USB
device, but your Tablet PC
does not recognize the
device, or the device does
not seem to work properly.

PC Card Problems

A card inserted in the PC
Card slot does not work or
is locking up the system.

Power Failures

You turn on your Tablet PC
and nothing seems to
happen.
60
Possible Cause
Modem may not have been
initialized.
The device is not properly
installed.
The device may have been
installed while an application
was running, so your Tablet PC
is not aware of its installation.
Your software may not have
the correct software driver
active.
Your device and another device
are assigned the same I/O
address.
The card is not properly
inserted.
The card may have been
inserted while an application
was running, so your Tablet PC
is not aware of its insertion.
Your software may not have
the correct software driver
active.
Your PC Card device and
another device are assigned the
same I/O address.
The installed battery is
completely discharged or there
is no power adapter (AC or
Auto/Airline) installed.
The battery is installed but is
faulty.
Possible Solutions
Verify that the modem has been initialized by the
operating system. To do so, right-click on My
Computer and select the Hardware tab. Click
[Device Manager] and click on the "+" symbol that
appears next to Modems. Verify that your device is
listed as installed.
Remove and re-install the device. See "Device Ports"
on page 53.
Close the application and restart your Tablet PC.
See your software documentation and activate the
correct driver.
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Remove and re-insert the card. See "PC Cards" on
page 49.
Close the application and restart your Tablet PC.
See your software documentation and activate the
correct driver.
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check the Status Indicator Panel to determine the
presence and condition of the battery. See "Status
Indicator Panel" on page 16. Install a charged
battery or a Power adapter.
Use the Status Indicator Panel to verify the presence
and condition of the battery. See "Status Indicator
Panel" on page 16. If a battery is indicating a short,
remove that battery and operate from another
power source or replace that battery.