HP MSA 2040 Installation Instructions

HP
Fibre Channel Transceiver

Installation Instructions

Abstract
This document details procedures for installing a Small
Form-factor Pluggable (SFP) Fibre Channel transceiver.
© Copyright 2010–2013 Hewlett-Packard Development Company, L.P.
Printed in the US
HP Part Number: 718624-001
Published: June 2013
Edition: 1
*718624-001*

About this document

For the latest product documentation, see the HP
website at http://www.hp.com/support/manuals.
Under the storage banner, navigate to the page
for your storage enclosure.
Warranties for HP products and services are set
forth in the express warranty statements
accompanying such products and services.
Nothing herein should be construed as constituting
an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained
herein. To obtain a copy of the warranty for this
product, see the warranty information website:
http://www.hp.com/

Before you begin

Observe the following:
CAUTION:
Transceivers that have been dropped may
be damaged. Problems resulting from a
dropped transceiver include intermittent
errors and no port link. Mishandling
fiber-optic cables can degrade
performance. Do not fold, pinch, or step
on fiber-optic cables. Do not bend
fiber-optic cables tighter than a 2-inch
radius.
Parts can be damaged by electrostatic
discharge; use proper anti-static protection.
Keep parts in electrostatic containers until
needed and ensure you are properly
grounded when touching static-sensitive
components.
Installing the transceiver
1. Slide the transceiver into slot until it locks in place.
2. Lift up or rotate down the small handle to secure
the transceiver.
3. Remove the dust cover from the transceiver port.
4. Reconnect the fiber-optic cable.
Page 1
go/storagewarranty.