Dell PowerVault DX6104 Owner's Manual page 62
Dell dx6104-csn, dx6104-scn, and dx6104-sn systems owner's manual
Hide thumbs
Also See for PowerVault DX6104:
- User manual (39 pages) ,
- Administrator's manual (176 pages) ,
- Reference manual (131 pages)
Table of Contents
Advertisement
1.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
2.
Open the system.
3.
Remove the expansion-card riser 1 and any card installed in the riser.
4.
Locate the internal dual SD module installed on the IDSDM connector on the system board.
5.
If applicable, remove the SD card(s).
6.
Holding the tab, pull the dual SD module to remove it from the system board.
7.
Replace the expansion-card riser 1 and if applicable, replace the card in the riser.
8.
Close the system.
9.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 25. Removing and Installing the Internal Dual SD Module
1. blue pull tab
2. SD card 1
3. SD card 2
4. dual SD module
5. connector on the system board
62
Advertisement
Table of Contents
Troubleshooting
