Table of Contents
Advertisement
L i f e B o o k P S e r i e s N o t e b o o k B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies which ATA
devices are installed.
Main
Type:
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
PIO Transfer Mode:
DMA Transfer Mode:
F1
Help
ESC
Exit
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu
Options
Field
Type:
• Auto
• None
• CD-ROM
• Hard Disk
Cylinders:
• A number between
0 and 65,535
Heads:
• A number between 1
and 16
Sectors:
• A number between
0 and 63
4
PhoenixBIOS Setup Utility
Advanced
Security
Primary Master [FUJITSU MK3018GAP-(PM)]
[Auto]
30006MB
[16 Sectors]
[Enabled]
[Fast PIO 4]
[Ultra DMA 4]
Select Item
-/Space
Select Menu
Enter
Figure 2. Primary Master Submenu
Default
[Auto]
–—
–—
–—
Note: Actual hard drive label shown may vary. Depending
on the drive type, information such as cylinders, heads and
sectors may also be displayed.
Power
Boot
Info
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Change Values
Select
Sub-Menu
Description
(Note: There is no drop-down menu available for the Type field. To change
the options, use the plus "+" and minus "-" keys or the spacebar.)
Selects the ATA/ATAPI device type. Select Auto to have the type automati-
cally identified by the BIOS at POST. If None is selected, all of the following
Set-up items do not appear. If Hard Disk is selected, you must specify the
number of Cylinders, Heads, and Sectors for the drive.
This item appears only when the type is identified as Hard Disk. When Hard
Disk is selected, you can change the value. This field is changed by incre-
menting (pressing the [Spacebar]) or by typing in the number.
This item appears only when the type is identified as Hard Disk. When Hard
Disk is selected, you can change the value. This field is changed by incre-
menting (pressing the [Spacebar]) or by typing in the number.
This item appears only when the type is identified as Hard Disk. When Hard
Disk is selected, you can change the value. This field is changed by incre-
menting (pressing the [Spacebar]) or by typing in the number.
Exit
Item Specific Help
F9
Setup Defaults
F10
Save and Exit
Advertisement
Table of Contents
