Installing The Ap - Dell PowerConnect B-RX4 Installation Manual

Installing the AP

CAUTION: Installation and service of Dell PowerConnect W-Series products should be performed by Professional Installers.
Using the Ceiling Rail Adapter
The access point ships with two ceiling rail adapters for 9/16" and 15/16" ceiling rails.
CAUTION: Make sure the AP fits securely on the ceiling tile rail when hanging the device from the ceiling, because poor
installation could cause it to fall onto people or equipment.
1. Pull the necessary cables through a prepared hole in the ceiling tile near where the AP will be placed.
2. Place the adapter against the back of the AP with the adapter at an angle of approximately 30 degrees to the
tabs (see
3. Twist the adapter clockwise until it snaps into place in the tabs (see
Figure 3
4. If necessary, connect the console cable to the console port on the back of the AP.
6
Figure 3).
Attaching the Ceiling Rail Adapter
Dell PowerConnect W-IAP130 Series Instant Access Point | Installation Guide
Figure 3).