About This Guide; Optional Accessories; System Requirements; Hardware Overview - D-Link DWL-2600AP Quick Installation Manual

About This Guide

This installation guide provides basic instructions
for installing the DWL-2600AP Wireless Access
Point on your network. For additional information
about how to use the Access Point, please see
the User Manual, which is available on the CD
included in this package or from the D-Link
support website.

System Requirements

- CD-ROM Drive
- Windows , Macintosh
®
operating system
- Ethernet port or installed Ethernet adapter
- Internet Explorer 7.0, Safari 5.0, Firefox 4.0,
or higher
Unpacking the Product
Open the shipping carton and carefully unpack its
contents. Please consult the packing list located
in following information to make sure all items are
present and undamaged. If any item is missing
or damaged, please contact your local D-Link
reseller for replacement.
- DWL-2600AP 802.11n Unified Access Point
- Power Adapter
- Mounting Ring
- Ethernet Cable
- Console Cable*
- CD-ROM
Note: Using a power supply with a different
voltage than the one included with the
DWL-2600AP may cause damage and will void
the warranty for this product.
*The console cable is an optional accessory and
not included in the package in Armenia, Azerbaijan,
Belarus, Georgia, Israel, Kaliningrad, Kazakhstan,
Kyrgyzstan, Latvia, Lithuania, Moldova, Mongolia,
Russia, Turkey, Turkmenistan, Ukraine, and
Uzbekistan. If a cable is required, please contact
your reseller to order it (Model: ACS-AP-CONSOLE).
2  D-Link DWL-2600AP Quick Install Guide
, or Linux-based
®

Optional Accessories

- PoE Base Unit (Model: DPE-101GI)
Note: These accessories are not included in
the package. If any of these items are required,
please contact your reseller to order it.

Hardware Overview

LEDs
Figure 1. DWL-2600AP LEDs
2.4 GHz – When this LED is lit up, the access
point's 2.4 GHz radio is enabled. It will
blink when there is wireless traffic.
LAN – When this LED is lit up, the device's
Ethernet port is connected to an active
router or switch. The light will blink
when there is traffic going through
the port.
POWER – When the LED is lit up, the access
point is powered and ready for use.
Interfaces
Console Port
LAN Port (PoE)
Figure 2. DWL-2600AP Rear Panel
LAN
Power Receptor