About This Guide; System Requirements; Optional Accessories; Hardware Overview - D-Link DWL-3600AP Quick Installation Manual

About This Guide

This installation guide provides basic
instructions for installing the DWL-3600AP
802.11n Unified Access Point on your network.
For additional information about how to use the
Access Point, please see the User Manual, which
is available on the CD included in this package or
from the D-Link support website.

System Requirements

- CD-ROM Drive
- Ethernet port or installed Ethernet adapter
- Internet Explorer 7.0, Safari 5.0, Firefox 4.0,
Chrome 20 or higher

Unpacking the Product

Open the shipping carton and carefully unpack its
contents. Please consult the packing list located
in following information to make sure all items are
present and undamaged. If any item is missing
or damaged, please contact your local D-Link
reseller for replacement.
- DWL-3600AP 802.11n Power over Ethernet
(PoE) Unified Access Point
- Mounting Ring
- Ethernet Cable
- Console Cable*
- CD-ROM
- Ceiling Bracket (3 sets, sizes are 9/16", 14/16",
and 1 1/2")
NOTE no PSU supplied. To power the units
use an D-Link PoE switch or the D-Link
DPE-101GI PoE injector.
*The console cable is an optional accessory and
not included in the package in Armenia, Azerbaijan,
Belarus, Georgia, Israel, Kaliningrad, Kazakhstan,
Kyrgyzstan, Latvia, Lithuania, Moldova, Mongolia,
Russia, Turkey, Turkmenistan, Ukraine, and
Uzbekistan. If a cable is required, please contact
your reseller to order it (Model: ACS-AP-CONSOLE).
2  D-Link DWL-3600AP Quick Install Guide

Optional Accessories

- PoE Base Unit (Model: DPE-101GI)

Hardware Overview

LEDs
Figure 1. DWL-3600AP LEDs
2.4 GHz – When this LED is lit up, the access
point's 2.4 GHz radio is enabled. It will
blink when there is wireless traffic.
LAN – When this LED is lit up, the device's
Ethernet port is connected to an active
router or switch. The light will blink
when there is traffic going through
the port.
POWER – When the LED is lit up, the access
point is powered and ready for use.
Interfaces
5V 2.5A
Power Receptor
(*Note no longer
Reset Port
used, replaced
by PoE)
Figure 2. DWL-3600AP Rear Panel
RESET
LAN Port (PoE)
Console Port