Back-Panel Features And Indicators - Dell PowerVault DL4000 Owner's Manual

Drive-Status Condition
Indicator Pattern
(RAID Only)
Blinks green three Rebuild aborted
seconds, amber three
seconds, and off six
seconds

Back-Panel Features And Indicators

Figure 3. Back-Panel Features and Indicators
Item Indicator, Button, or
Connector
1 System identification button
2 System identification
connector
3 iDRAC7 Enterprise port
4 PCIe expansion card slot
(riser 1)
5 Serial connector
6 Video connector
7 PCIe expansion card slot
(riser 2)
8 USB connectors (2)
10
Icon Description
The identification buttons on the front and back panels
can be used to locate a particular system within a rack.
When one of these buttons is pressed, the system status
indicator on the back flashes until one of the buttons is
pressed again.
Press to toggle the system ID on and off. If the system
stops responding during POST, press and hold the system
ID button for more than five seconds to enter BIOS
progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup) press
and hold for more than 15 seconds.
Allows you to connect the optional system status indicator
assembly through the optional cable management arm.
Dedicated management port.
NOTE: The port is available for use only if the iDRAC7
Enterprise license is installed on your system.
Allows you to connect a PCIe expansion card.
Allows you to connect a serial device to the system.
Allows you to connect a VGA display to the system.
Allows you to connect a PCIe expansion card.
Allows you to connect USB devices to the system. The
ports are USB 2.0-compliant.