5.6
Power menu
Main
Advanced
ACPI APIC support
APM Configuration
Hardware Monitor
5.6.1
ACPI APIC Support [Enabled]
Allows you to enable or disable the Advanced Configuration and Power Interface
(ACPI) support in the Advanced Programmable Interrupt Controller (APIC). When
set to [Enabled], the ACPI APIC table pointer is included in the RSDT pointer list.
Configuration options: [Disabled] [Enabled]
5.6.2
APM Configuration
Power On Configuration
Restore on AC Power Loss
Power On PCIE Wake#
Power On Ring
Power On RTC Alarm
Restore on AC Power Loss [Last State]
When set to [Power Off], the system goes into off state after an AC power loss.
When set to [Power On], the system will reboot after an AC power loss. When set
to [Last State], the system goes into either off or on state, whatever the system
state was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
Power On PCIE Wake# [Disabled]
Allows you to enable or disable the PCIE devices to generate a wake event.
[Disabled]
[Enabled]
5-28
Server
v02.61 (C)Copyright 1985-2010, American Megatrends, Inc.
[Last State]
[Disabled]
[Disabled]
[Disabled]
Disables the PCIE devices to generate a wake event.
Enables the PCIE devices to generate a wake event.
BIOS SETUP UTILITY
Power
Boot
Tools
[Enabled]
BIOS SETUP UTILITY
Power
Exit
Include ACPI APIC
table pointer to
RSDT pointer list.
Select Screen
←→
Select Item
↑↓
+-
Change Option
F1
General Help
F10
Save and Exit
ESC
Exit
Options
Power On
Power Off
Last State
Chapter 5: BIOS setup