Data Transferring Commands From Host To Device; Figure 5.4 Protocol For Command Abort - Fujitsu MHJ2181AT Product Manual

device to 50 ms after the completion of the sector data transfer.
Note that the host does not need to read the Status register for the
reading of a single sector or the last sector in multiple-sector
reading. If the timing to read the Status register does not meet
above condition, normal data transfer operation is not guaranteed.
When the host new command even if the device requests the data
transfer (setting in DRQ bit), the correct device operation is not
guaranteed.

5.4.2 Data transferring commands from host to device

The execution of the following commands involves Data transfer from the host to
the drive.
WRITE SECTOR(S)
WRITE LONG
WRITE BUFFER
WRITE VERIFY
SECURITY DISABLE PASSWORD
SECURITY ERASE UNIT
SECURITY SET PASSWORD
SECURITY UNCLOK
The execution of these commands includes the transfer one or more sectors of data
from the host to the device. In the WRITE LONG command, 516 bytes are
transferred. Following shows the protocol outline.
C141-E088-03EN

Figure 5.4 Protocol for command abort

5.4 Command Protocol
5-81