Table 4.44 Sense Key; Table 4.45 Logical Track Address Format - Fujitsu MCJ3230SS Product Manual

Host Interface
Sense
Mnemonic
Key
0h NO SENSE
1h RECOVERED
ERROR
2h NOT READY
3h MEDIUM
ERROR
4h HARDWARE
ERROR
5h ILLEGAL
REQUEST
6h UNIT
ATTENTION
7h DATA
PROTECT
8h BLANK CHECK
9h- Reserved
Ah
Bh ABORTED
COMMAND
Ch-
Reserved
Fh
Information indicates the LBA of the block in which an error occurred. If errors
occur in multiple blocks, Information indicates the LBA of the block in which the
first error occurred.
Command-Specific Information indicates the logical track address of the block
indicated by Information. The format of the logical track address is shown in
Table 4.45.
Byte
8-9
10
11
Additional Sense Code (ASC) and Additional Sense Code Qualifier (ASCQ)
indicate detailed error information. Table 4.46 lists the ASC and ASCQ
definitions.
4-28

Table 4.44 Sense Key

There is no sense key to be reported. NO SENSE is set when
a command ends normally.
Recovery processing ended successfully or the commands
ended normally using the internal default values even though
invalid data was detected in command parameters. (This sense
data is not reported if the PER bit is 0.)
No access commands can be used.
An unrecoverable error due to media failure was detected.
An unrecoverable error due to hardware failure was detected.
A command packet or command parameter contains invalid
data; media data remains unchanged.
Reset state, power-on, or media replacement was caused.
Media is write-protected with the write-protect switch or with
software.
A blank sector was detected. This sense key is reserved.
Reserved
Processing of the command was interrupted.
Reserved

Table 4.45 Logical track address format

Description
Logical track address
Logical sector address
Meaning
00h
C156-E224-01EN