Adaptive Vibration Control; Floor Type Selection - GE GFWR4805FMC Installation Instructions Manual

ADAPTIVE VIBRATION CONTROL

Your GE washer is equipped with Adaptive Vibration Control
Technology. Using information about the floor, this system
can reduce vibration and improve spin performance in
some installations by adapting the spin cycle. The DEFAULT
configuration is specially designed to provide optimal
performance across the widest range of floor types. Follow
the procedure below to enable more specific adaptive
settings. Your washer can be returned quickly and easily
to the DEFAULT configuration at any time using the same
procedure.

Floor Type Selection

1. Place control in the idle state. (Make sure no cycles or
options are selected but that the washers Power is on.)
2. Press and hold the Power and Spin buttons at the same
time for 3 seconds.
3. Only the Power, Start and display lights will be lit in this
mode.
4. Pressing the Power button in this mode will return the
control to the idle state and the defaults will be restored.
5. Rotate the selector knob to select the Floor Type, per
the following table.
Display
F0 Default
F1 Concrete Floor
F2 Second Floor, all surface types
F3 First Floor, Tile Surface
F4 First Floor, Linoleum surface
F5 First Floor, wood surface
24
Installation Instructions
Floor Type
6. Press the Start button to make selection.
o For GE RightHeight Design™ frontload washers with a
Built-In Riser™ models (GFWR4800 and GFWR4805) – Exit
the Floor Type selection mode and return to the idle state
after the Start button is pressed. The programming of
your washers Adaptive Vibration Control is now complete.
o For all other models (GFWS2500, GFWS2505, GFWS2600,
GFWS2605, GHWS3600, GHWS3605, GFWS3700 and
GFWS3705) – proceed to the pedestal selection (steps
7-9).
7. Rotate the selector knob to select the Pedestal Type, per
the following table.
Display
P0 No Pedestal (Default setting)
P1 Pedestal
8. Press the Start button to make selection.
9. Exit the Pedestal Type selection mode and return to the
idle state after the Start button is pressed.
Pedestal Type