Samsung 226BW Service Manual page 37

10 Operating Instructions and Installation
2,3. Adjust buttons
Adjust items in the menu.
4. Enter button / Source button
Activates a highlighted menu item. /
Push the 'SOURCE', then selects the video signal
while the OSD is off. (When the source button is
pressed to change the input mode, a message
appears in the left upper side of the screen
displaying the current mode -- analog or digital
input signal.)
Note : If you select the digital mode, you must con-
nect your monitor to the graphic card's port using
the DVI cable.
10-2 Rear
(The configuration at the back of the monitor may vary from product to product.)
1. POWER port
2. DVI IN (HDCP) port Connect the DVI Cable to the DVI port on the back of your monitor.
3. RGB IN port
4. Kensington Lock
10-2
Connect the power cord for your monitor to the power port on the back of the
monitor.
Connect the signal cable to the 15-pin, D-sub port on the back of your monitor.
The Kensington lock is a device used to physically fix the system when using it in
a public place.
(The locking device has to be purchased separately.
For using a locking device, contact where you purchase it.)
5. Auto button
When the 'AUTO' button is pressed, the Auto
Adjustment screen appears as shown in the ani-
mated screen on the center. Auto adjustment
allows the monitor to self-adjust to the incoming
video signal. The values of fine, coarse and posi-
tion are adjusted automatically. (Available in ana-
log mode only)
6. Power button
Use this button for turn the monitor on and off.