Yamaha RX-A1010 Owner's Manual page 26

1 2 3 4 5 6 7 8 9
Speaker connections
■
Connecting front speakers that support bi-amp connections
When using front speakers that support bi-amp connections, connect them to the
FRONT jacks and EXTRA SP1 jacks.
To enable the bi-amp function, configure the "Power Amp Assign" setting (p.104) in the
"Setup" menu after connecting the power cable to an AC wall outlet.
This unit (rear)
SURROUND SURROUND BACK ZONE 2/ZONE 3/R.PRESENCE
R L R L
R
SINGLE
Caution
• Before making bi-amp connections, remove any brackets or cables that connect a woofer with a
tweeter. Refer to the instruction manual of the speakers for details. When not making bi-amp
connections, make sure that the brackets or cables are connected before connecting the speaker
cables.
SPEAKERS
ZONE 2/ZONE 3/F.PRESENCE/
CENTER FRONT
BI–AMP
R L
L
EXTRA SP2 EXTRA SP1
R L
SPEAKER IMPEDANCE
■
Connecting Zone2/3 speakers
When using Zone2/3 speakers, connect them to the EXTRA SP1~2 jacks.
To utilize the EXTRA SP1~2 jacks for Zone2/3 speakers, configure the "Power Amp
Assign" setting (p.104) in the "Setup" menu after connecting the power cable to an AC
wall outlet.
This unit (rear)
ZONE 2/ZONE 3/R.PRESENCE
SURROUND SURROUND BACK
R L R L
R
SINGLE
Main zone
• You can select a zone (Zone2 or Zone3) to be assigned to the EXTRA SP1~2 jacks in "Power Amp Assign"
(p.104) in the "Setup" menu. By default, Zone2 is assigned to the EXTRA SP1 jacks and Zone3 is assigned
to the EXTRA SP2 jacks.
• You can also connect Zone2 and Zone3 speakers using an external amplifier (p.81).
SPEAKERS
ZONE 2/ZONE 3/F.PRESENCE/
CENTER FRONT
R L BI–AMP
EXTRA SP2 L EXTRA SP1
R L
SPEAKER IMPEDANCE
Zone2 Zone3
26
En