Setup Menu Items - Yamaha RX-A1010 Owner's Manual

Setup menu items

Menu Item
Auto Setup
Setting Pattern
Setting Data Copy
Power Amp Assign
Configuration
Speaker
Manual Setup
Distance
Level
Parametric EQ
Test Tone
Lipsync
Dynamic Range
Max Volume
Sound
Initial Volume
Pure Direct Mode
Adaptive DSP Level
Analog to Analog Conversion
Video
Processing
HDMI Control
HDMI Audio Output
Standby Through
Function
Optimizes the speaker settings automatically (YPAO).
Registers two speaker setting patterns and switches between them.
Copies the "Setting Pattern" parameters in the specified direction.
Selects a speaker system.
Front Selects the size of the front speakers.
Center Selects whether or not a center speaker is connected and its size.
Surround Selects whether or not surround speakers are connected and its size.
Surround Back Selects whether or not surround back speakers are connected and its size.
Front Presence Selects whether or not front presence speakers are connected.
Rear Presence Selects whether or not to rear presence speakers are connected.
Subwoofer 1
Selects whether or not a subwoofer is connected to the SUBWOOFER 1 or SUBWOOFER 2 jack and its phase.
Subwoofer 2
SWFR Layout Selects a subwoofer layout when 2 subwoofers are used.
Extra Bass Sets the speakers to produce the front channel low-frequency components.
Sets the distance between each speaker and listening position.
Adjusts the volume of each speaker.
PEQ Select Selects a type of equalizer to be used.
PEQ Data Copy Copies the parametric equalizer values acquired with "Auto Setup" to the "Manual" fields for fine adjustment.
Enables/disabled the test tone output.
Adjusts the delay between video and audio output.
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and DTS signals) playback.
Sets the maximum volume so that sound is not too loud.
Sets the initial volume for when this receiver is turned on.
Selects whether to output video signals during the Pure Direct mode.
Selects whether to automatically adjust the CINEMA DSP effect level in conjunction with volume adjustments.
Enables/disables the video conversion between the analog video jacks.
Enables/disables the video signal processing (resolution, aspect ratio and video adjustments).
Enables/disables HDMI Control. You can also configure the relevant settings (ARC, TV audio input, etc).
Selects a device to output audio.
Select whether to output videos/audio (input through HDMI jacks) to the TV when this unit is in standby mode.
Page
45
104
104
104
105
105
105
105
105
105
106
106
106
106
106
107
107
107
108
108
108
108
108
109
109
109
111
112
112
102
En