Table of Contents
Advertisement
9. Note
1)
If this driver is used with serial connections in Windows 95, it may be impossible to print normally with some combinations
of personal computer and printer. In this case, it will be possible to print normally by lowering the setting value for the FIFO
transmit buffer in the Windows 95 COM port settings.
2)
If this driver is used with serial connections in Windows NT 4.0 or Windows2000/XP, it may be impossible to print
normally with some combinations of personal computer and printer. In this case, it will be possible to print normally by
disabling FIFO in the Windows NT 4.0,Windows2000,WindowsXP COM port detailed settings.
3)
When printing on receipt paper blank space is taken at the top of the paper which is greater than the top margin setting value.
This is due to the interval which is provided between the paper's cut position and the print position.
4)
Even if strike through, italics and other attributes are specified for characters printed using printer fonts, they are
disregarded. If you want to use these attributes, use Windows fonts.
5)
If the print direction is set on horizontal, printing cannot be done using printer fonts. Please use Windows fonts.
6)
If a printer font and graphics data (Windows font or ruled line, etc.) are defined on the same line, the printing results could
deviate.
7)
If printer font double height characters (large size characters specified) and characters from other fonts are defined on the
same line, the printing results could deviate.
8)
If you are using the printer with serial connections, the expected print speed cannot be obtained. In order to print at higher
speeds, it is recommended that the printer be used with the exception of serial connections.
9)
If you are using the printer with parallel connections, if the power is turned on with the paper at the near end position, a no
paper error will occur and it will be impossible to print. After adding new paper, turn off the power, then turn it on again.
10) In Windows 95/98, if you set the printer driver's print spool on "Disable bi-directional support," and a program is run which
uses the Status Monitor API, it will become impossible to print from another application. If you are running a program
which uses the Status Monitor API, be sure to set "Enable bi-directional support."
11) With some computers, if the ECP mode is set for the parallel port operating mode, it may become impossible to print
normally or to use Status Monitor API. In this case, clear the ECP Mode setting.
12) In Windows NT4.0, Windows2000 or WindowsXP, bold printing of printer fonts is not possible. Except DBCS Character.
13) Driver EPSON DM-D10X/20X doesn't support DM-D202. Also, If TM printer doesn't work if it is connected with
DM-D202.
14) If any of Customer display DM-D101, 105 or 205 is used independently without connecting to TM Printer, it may not
displayed correctly. If so, please connect the connect terminal of Customer Display's Printer with the loop-back connector
which is shorted between TxD-RxD and DTR-DSR and RTS-CTS.
EPSON
TITLE
EPSON Advanced Printer Driver for TM series
Printer Driver
TM
User's Manual
Revision
No
NEXT
L
21
SHEET
20
Advertisement
Table of Contents
