Receiving A Call Hands-Free; To Return To The Factory Preset State - Panasonic SC-NA10 Owner's Manual

Receiving a call hands-free

If receiving a call on the mobile phone connected to this unit with Bluetooth
can make a hands-free call through this unit.
Preparation
Connect this unit and the mobile phone with Bluetooth
Receiving a call
∫
Press [ ] when this unit rings.
• When receiving the call, the Bluetooth
• Talk into the microphone (
Ending the call
∫
Press [ ].
Note
• Adjust the volume during a call with volume knob on this unit.
• When the mobile phone and the unit are connected with Bluetooth
and have a conversation on the mobile phone, the unit may also output the incoming voice. To
switch from a hands-free call using the unit to a call using only the mobile phone, operate the
mobile phone.
• If a call is received during audio playback using a Bluetooth
automatically switch to the ringtone.
If a call is received while the AUX IN jack is in use, the sound will switch to the ringtone of the
mobile phone connected with Bluetooth
• If you touch other devices to the NFC touch area of this unit when receiving a call, Bluetooth
connection will not switch.
• To mute the ringtone, turn the volume knob of the unit to [- VOL] until no sound can be heard.
• Some apps for the mobile phone may not be available for hands-free.
• In a place with poor mobile phone reception, it may be harder to have a conversation. Use the
mobile phone in a place with good reception.
• In a place where voices echo considerably, such as an area near a wall, it may be harder to
have a conversation. Before using the unit, move it away from the wall or lower its volume.

To return to the factory preset state

Perform the following when you want to delete pairing device information, etc.
Preparation
Turn off the unit, and remove the AC adaptor.
Press and hold [Í/I] for 10 seconds until Bluetooth
Mode indicator (green) blink twice.
The pairing device information will be deleted by the reset, so it will be necessary to
perform pairing again. Delete the pairing information for this unit from the
Bluetooth device, then perform the pairing operation again. (
®
14
indicator (blue) on the unit blinks.
®
6, 7) on this unit.
.
®
.
®
, even if you receive a call
®
connection, the sound will
®
indicator (blue) and LP
®
10, 11)
, you
®
®