Onkyo PA-MC5501 Instruction Manual page 12

Connecting the Speaker Cables
1
Strip about 1/2" to 5/8" (12
to 15 mm) of insulation from
the ends of the speaker
cables, and twist the bare
wires tightly, as shown.
2 Unscrew the terminal.
The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one
surround back speaker, connect it to the SURR BACK L terminal.
Note
• If you use front high or front wide speakers, you must turn on the AV controller and select the speakers to be used.
For more details, see the instruction manual of the connected component.
The amplifier
Front
high/wide
right
En
12
1/2" to 5/8"
(12 to 15 mm)
Surround Front right
right
Surround
back right
3
Fully insert the bare wires.
4
Screw the terminal tight.
Select 4Ω or 6Ω.
Center Front left Surround
left
Surround Front
back left high/wide
left