D-Link DGS-3620-28SC-EI Hardware Installation Manual page 35

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Hardware Installation Guide
Note: When using HyperTerminal with the Microsoft® Windows® 2000 operating system, ensure that
Windows 2000 Service Pack 2 or later is installed. Windows 2000 Service Pack 2 allows the use of
arrow keys in HyperTerminal's VT100 emulation. See www.microsoft.com for information on Windows
2000 service packs.

After you have correctly set up the terminal, plug the power cable into the power socket on the back of the
DGS-3620 Series switch. The boot sequence appears in the terminal.

After the boot sequence completes, the console login screen displays.

If the user has not logged into the command line interface (CLI) program, press the Enter key at the User name
and password prompts. There is no default user name and password for the Switch. The administrator must
first create user names and passwords. If user accounts have been previously set up, log in and continue to
configure the Switch.

Enter the commands to complete the desired tasks. Many commands require administrator-level access
privileges. Read the next section for more information on setting up user accounts. See the Switch CLI Manual
on the documentation CD for a list of all commands and additional information on using the CLI.

To end a management session, use the logout command or close the emulator program.
If you experience problems while making a connection, make sure the emulation is set to VT-100. The emulation
settings can be configured by:
1. Click File Menu in HyperTerminal
2. Click Properties from the drop-down menu
3. Click the Settings Tab
This is where you will find the Emulation options. If you still do not see anything, try rebooting the Switch by
disconnecting its power supply.
Once connected to the console, the image in Figure 4-1 appears. This is where the user will enter commands to
perform all the available management functions. The DGS-3620-Series Switch will prompt the user to enter a user
name and password. Logging on at the beginning requires no username or password. Just press the Enter key twice
to access the command line interface.
Boot Procedure
-------------------------------------------------------------------------------
Power On Self Test ........................................
MAC Address : 00-11-22-33-44-55
H/W Version : A1
Please Wait, Loading V2.00.015 Runtime Image ..............
UART init .................................................
Starting runtime image
Device Discovery ..........................................
Configuration init ........................................
Figure 4–1 Boot up display in console screen
35
V1.00.016
100 %
100 %
100 %
100 %
100 %