Creating An Inventory Of Cartridges - Dell PowerVault 122T SDLT 320 User Manual

NOTE: If you are using Operator's Panel commands to clean the drive, import the cleaning cartridge only after you
have selected the Clean Drive command. If you would like to keep a cleaning cartridge in the autoloader, the backup
software must manage drive cleaning.
To clean the tape drive, follow these steps:
1. From the Home screen or main menu, press + or - until Commands appears on the top line of the LCD screen, and then press Enter.
2. Press + or - until Clean Drive appears on the LCD screen, and then press Enter.
3. If the carousel is full, the LCD screen displays No slot free for transfer. Press Cancel repeatedly until the main menu or Home screen is displayed.
Export a cartridge to make room for the cleaning cartridge. See
4. If the carousel is not full, the autoloader will select the first available slot and prompt you to insert a cleaning cartridge.
5. Insert the cleaning cartridge into the autoloader media door.
6. During the cleaning process, which can take up to five minutes, the LCD screen displays Drive Cleaning.
NOTE: If the cartridge is not a valid cleaning cartridge, the LCD screen will display Bad clean tape and the
cartridge is ejected. If a standard Super DLT I data cartridge is inserted, no message appears and the cartridge
is ejected.
7. When tape drive cleaning is complete, the Clean Drive LED turns off (if previously on) and the autoloader unloads and exports the cleaning cartridge.
Remove the cleaning cartridge, and press Enter when the LCD screen prompts you to do so.
NOTICE: If the Clean Drive or Media Attention LED is illuminated again when you insert another cartridge
immediately after cleaning, see "Troubleshooting."
8. If you had to remove a data cartridge to import the cleaning cartridge, import that data cartridge to its original slot (see

Creating an Inventory of Cartridges

This option builds a new inventory of cartridges in the autoloader. If using a bar code reader, this option also scans the bar code labels on each cartridge in
the carousel (see "Bar Code Reader"). To use this option, follow these steps:
1. From the Home screen or main menu, press + or - until Commands appears on the top line of the LCD screen.
2. Press Enter to access the available options.
3. Press + or - until Re-inventory appears on the LCD screen and then press Enter.
4. The autoloader will then check the drive and each slot for the presence of a tape in order to update the inventory information.
Back to Contents Page
"Exporting Cartridges" for instructions, then return to step 1 to clean the tape drive.
"Importing Cartridges").