Installing Your Powerline Av 500 Adapter; Prepare For Installation - NETGEAR XAV5001 - Powerline AV 500 Adapter User Manual

XAV5001 Powerline AV 500 Adapter User Manual

Installing Your Powerline AV 500 Adapter

Prepare for Installation:

1. Before you begin, verify the following:
• Your Ethernet network is set up.
• An Ethernet port is available on your router.
• Your Internet connection is working.
• An Ethernet port is available on each computer that will use a Powerline AV Ethernet
Adapter and is configured to work on your network. Usually, the default configuration
settings (TCP/IP and DHCP) are fine.
2. Familiarize yourself with the Powerline AV Ethernet Adapter.
The front panel has three lights: Power, Powerline, and Ethernet. The side panel has a
Security button, and a Reset button. The Ethernet port is located on the bottom of the
adapter. See Figure 2
3. Plan the location of your Powerline devices:
• Use an electrical outlet that is not controlled by a wall
switch to avoid someone unknowingly turning off the
power to the outlet.
• Do not connect the Powerline AV Ethernet Adapter to
a power strip, extension cord, or surge protector as
this might prevent it from working correctly, or reduce
the network performance.
• Avoid using the Powerline AV Ethernet Adapter in an
electrical outlet that is located near an appliance that
uses a lot of power, such as a washer or dryer, or a
refrigerator. This could potentially prevent the adapter
from working correctly, or reduce network
performance.
on page 5.
Chapter 1. Installation and Basic Configuration | 7