Dell Force10 S25-01-GE-24P Configuration Manual page 7

To apply the configuration, above, to other stack members, use the following commands. The interface
range used and port-pipes ("
sequence presumes that the subject stack member is an S25P model. For an example of configuring an
S50N model, see Basic Layer 2 Setup and Buffer Tuning of the S50N for Storage Environments.
Step Task
1 Apply the "eql-hig"
buffer profile to another
stack member.
2 Select all ports on the
switch.
3 Apply the "eql-fp" buffer
profile to the ports
selected above.
4 Change modes from
INTERFACE RANGE to
CONFIGURATION.
5
Select all 1GbE ports.
6 Enable flow control on
the 1GbE ports.
7
Change modes from
INTERFACE RANGE to
EXEC privilege.
8 Save the configuration to
non-volatile memory.
9 Restart the system.
10 Verify that the buffer
profile is applied.
101-00337-00
") designated would depend on the S-Series model. The following
port-set 0-1
Command Syntax
buffer fp-uplink stack-unit 0-7 port-set
buffer-policy eql-hig
For the variable 0-7 , enter the stack ID of the stack member
to which to apply the "eql-hig" configuration.
For example, for an S25P switch with a stack ID of 1, the
command is:
buffer fp-uplink stack-unit 1 port-set 0
buffer-policy eql-hig
interface range gi slot/port - port
For the variable slot/port
stack member, along with 1 for the beginning port number in
the range and 24 for the highest-numbered 1GbE port.
For example, for an S25P switch with a stack ID of 1, the
command is: interface range gi 1/1 - 24
If the switch has 10 GbE modules inserted, include the 10
GbE port range in the command, for example:
interface range gi 1/1 - 24, te 1/25 - 28
buffer-policy eql-fp
exit
interface range gi slot/1 - 24
For , enter the stack ID of of the target stack member.
slot
For example, for a stack ID of 1, enter:
interface range gi 1/1 - 24
flow-control rx on tx on
end
write memory
reload
show buffer-profile summary fp-uplink
0
, enter the stack ID of the target
Command Mode
CONFIGURATION
CONFIGURATION
INTERFACE
RANGE
INTERFACE
RANGE
CONFIGURATION
INTERFACE
RANGE
INTERFACE
RANGE
EXEC privilege
EXEC privilege
EXEC privilege
7